Create an account


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A Quick Look at Sex Dolls Today- Read Before You Buy

#1
[center][Image: nfaoxus406adxw2wnv657-1.jpg][/center]

[center]VIEW THE BEST SEX DOLL BEGINNER ADVICE TODAY[/center]

A Beginner's Guide To Using A Sex Doll: What To Know Before You Start
So you've bought your first doll, or you're on the point of doing so. Either way, there's a moment of mild panic when you unbox a 35 kg silicone human, end up standing in the middle of the living room, and ask yourself: now what? The answer to that question is what follows here. Expect real-world pointers only: what you will genuinely need in the initial week and what will save you from pricey blunders in the opening month, with zero fluff and no presumption that you have done this before. Read it twice: once before she arrives and once more after, as the second read makes much more sense and helps you area things you skipped over the first time.

Before you even open the package, several things are worth doing, because once she's out of the box, getting her around gets significantly harder. Make a decision for where she's going to live: not "somewhere in the bedroom" but a specific place, for example a wardrobe, a corner, or a storage container. Dolls are weighty and cumbersome, and you do not wish to be making up storage at 11 p.m. with an unclothed doll in your arms. Evident the space she'll rest on, be it a bed, floor, or storage box, and be sure it is clean and free of anything that could transfer dye, seeing as dark blankets, low-quality fabrics, and anything that might release dye pose a risk. With carpet, put something smooth underneath her. On a low bed, verify it will not sag under her load in time.

Before she arrives, have your supplies ready:
1. Baby powder or cornstarch (for TPE dolls)
2. A blow-dryer (for freeing up joints)
3. A clean, pale-coloured cloth (for the material test)
4. A coarse-toothed wig comb (not a standard hairbrush)
5. Drying sticks (for the cavities)
6. Mineral oil designed for TPE (where it applies)
7. A soft powder brush (for powdering)

It is all inexpensive, but every bit of it matters. The full kit will come to maybe twenty pounds and it is the distinction among a doll that stays in good condition and one that does not. Go attentively opening the package rather than tearing into it, and if it is damaged, image it first, as that is your only safeguard for a warranty case. Inspect her quickly once the package is open: look for rips in the armpits and groin, verify all fingers are in one piece, and verify the head sculpt matches what you paid for. If you spot a difficulty, picture it straight away and get in touch with the vendor before you do anything else, as a claim gets much harder once the doll has been used or repositioned.

After that comes the component that catches nearly every new buyer off guard: she will feel inflexible. Straight from the factory, the joints are tight, which is entirely regular and does not mean anything is damaged. You will have to limber up the joints before you can pose her, and the technique is straightforward. Take a hair dryer on a gentle setting, not hot, to soften the TPE at every joint, after that slowly move each joint through its whole range of motion, working through the neck, shoulders, elbows, wrists, hips, knees, and ankles. If a joint will not move, warm it more, and never force anything. Set aside a complete hour for this. It sounds excessive, but it is the distinction among a doll you will genuinely pose and a doll that ends up frozen in one pose as you gave up.

She's heavier than she looks, and this catches everyone. 35kg does not sound especially weighty till you're lifting her from a low position and the load is concentrated in the wrong places, so use right lifting technique: squat down and lift with your legs instead of your back. Where possible, hug her, taking hold under the armpits and keeping her close to your body, as the closer she is to your centre of mass, the less pressure you will feel. TPE and silicone both hold body warmth pretty well, so she's warmer than you anticipate, and the first time you contact her correctly she'll feel less plastic than you probably expected. This is the chief reason people talk about their dolls feeling alive, not since of movement or AI, but seeing as the material truly yields to feel in a manner that startles you.

TPE gets clammy in time, especially in hot weather or after cleaning, so powder her often: a thin layer of cornstarch or baby powder applied with a soft powder brush maintains the skin smooth and dust-free, and it should be done after each cleaning session. TPE sheds oil in time and needs replenishment, so oil her every so often: a thin coat of mineral oil made specifically for TPE dolls a few times a year maintains the cloth soft and prevents drying out, but don't go overboard, as excess oil makes the finish oily and gathers collect dust sooner than dehydrated skin does.

Cleansing is a procedure in place of a one-off. After use:
1. Take out any inserts and wash them separately
2. Clean the openings in warm water and gentle cleanser
3. Dry everything well with drying stands (fifteen to twenty minutes)
4. Powder the exterior with cornstarch or baby powder
5. Keep her sensibly

This isn't optional, since skip it and you'll get mould forming inside her in a few weeks. The entire procedure takes close to 45 minutes, which is longer than the majority of people anticipate, and it is the primary reason veteran owners switch to removable liners, which cut that time approximately in half.

Novice owners make their biggest blunder here, as they do not think about storage until it is a concern. Most seasoned owners hang their dolls, using a heavy-duty ceiling mount rated for at least 60 kg with a dedicated loop, which maintains her in the same position without putting stress on the joints. Storing her lying down works too, but be careful: flat surfaces are fine and rough ones aren't, and leaving her on her back for long periods can flatten the buttocks or breasts, so vary the position from time to time. UV damages both TPE and silicone and washes out wigs and painted details fast, so never leave her in strong sunlight, and keep her in a wardrobe or a covered storage box.

The internet has a lot of opinions about owning a doll, most of which are false or overstated. Yes, she's weighty and her joints need maintenance, but you needn't be "careful" in the sense of fussing over her, as she's designed to be used and she's not made of glass. Embarrassment isn't needed, as huge numbers of people own sex dolls, the industry has grown dramatically in the past ten years, and the social stigma has faded quickly, which makes owning one a personal decision and not something wrong with you.

Nor do you have to treat her like a person. Plenty of owners build complex characters and personalities for their dolls, which is great and aspect of the appeal for many people, but it is optional, and wanting a doll for bodily pleasure and companionship without the roleplay is a completely valid way to use one. Get the everyday side right and the rest is individual taste, seeing as nobody else has a say on how you use something you bought.

Each owner ends up with their own process, and mine, for what that's worth, is uncomplicated. Free up the joints ahead of every session, not a solid hour from the first time but just a short while to verify nothing is inflexible, and powder at the end of every clean without fail. Keep a second wig ready, as synthetic hair takes longer to dry out than you'd anticipate and you do not would like to be waiting, run the dye test on any fresh clothing even if you've used the same brand before, and put away her with care every time. It is not fiddly, just the regime that holds your doll in great condition for years on end on end in place of months.

Your first month will teach you the majority of what you have to know, and the blunders you make early tend to be minor ones provided you're careful. The things that go wrong later are the pricey ones, and they virtually always originate in something skipped in the first couple of weeks. A joint freed up too aggressively, a cloth tested on the doll rather than a cloth, a storage method that appeared fine until the load sunk into it. Go slowly at the beginning and the rest looks after itself.

There's also the question of what to do when something does eventually go wrong, as it will. A tear in the armpit, a loose joint, a mark that will not come out. The instinct is to panic and assume the doll is done for, but virtually everything short of a broken frame is fixable if you area it early. Mending kits for TPE cost very little and deal with compact rips. Loose joints can be tightened or changed. Marks will not come out, and that is why the dye test makes such a difference. Work out where the fixable issues are and stop fretting over the ones that aren't.

A doll is a big purchase that deserves respect, but "serious" does not mean "difficult." Free up the joints, powder her often, put away her with care, and you will get years out of her, but skip those things and you will be replacing her significantly sooner than you expected. Week one is the hardest component, and after that it becomes habit. More info at this A Quick Look at Sex Dolls Right Now- The Real Talk b9684_4 which is worth considering with The Real Overview of Sex Dolls Right Now- What Nobody Tells You and A Quick Look at Sex Dolls Today- The Real Talk. Also check out news bearing in mind like it and you can try these out for more.
[center][Image: lwje3h40r9td4hani42wf.jpg][/center]

[center]CHECK OUT THE BEST SEX DOLL GUIDE ONLINE[/center]
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Forum software by © MyBB Theme © iAndrew 2016