Create an account


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
The Definitive Look at Modern Sex Dolls- What Nobody Tells You

#1
[center][Image: nfaoxus406adxw2wnv657-1.jpg][/center]

[center]VIEW BEST SEX DOLL BEGINNER ADVICE TODAY[/center]

The Beginner's Guide To Using A Sex Doll: A Practical Walkthrough
Maybe you've already bought your first doll, or perhaps you're about to. In both cases, there's a moment of low-level panic when you unbox a 35 kg silicone human, end up standing in the middle of the living space, and wonder: now what? The answer to that question is this guide. You will not find fluff or assumptions that you have done this before here, just hands-on guidance on what you will truly need in your first week and how to steer clear of costly blunders in your first month. Read it once before she arrives and once again after she's here, since the repeat pass will make considerably more sense and you will spot things you missed the first time.

When she's out of the package, moving her around gets much harder, so a few things are worth doing before the package is even open. Have a plan for where she's going to live: not "somewhere in the bedroom" but an actual area, whether it is a cupboard, a corner, or a storage container. The last thing you wish is to be making up storage at 11 at night with a bare doll in your arms, seeing as dolls are weighty and unwieldy. Evident the space she'll rest on, be it a bed, floor, or carry case, and inspect it's clean and free of anything that could transfer dye, as dark-toned blankets, poorly dyed fabrics, and anything that might bleed colour are a risk. Carpet calls for something smooth under her. On a low bed, be sure it will not give way under her pressure with time.

Get your kit ready before she arrives:
1. Cornflour or baby powder (for TPE dolls)
2. A hair dryer (for easing joints)
3. A clean, pale-coloured cloth (for the material test)
4. A wide-toothed wig comb (not a regular hairbrush)
5. Drying rods (for the orifices)
6. Mineral oil made for TPE (where relevant)
7. A soft make-up brush (for powdering)

It is all cheap, but every bit of it matters. Maybe about £20 pays for the full kit, and it is the distinction among a doll that stays in good condition and one that does not. Do not tear into the package: open it with attention, and if it is damaged, image it before you open it, as that's your only cover for a warranty case. Inspect her quickly once the package is open: look for splits in the armpits and groin, verify all fingers are unbroken, and confirm the head sculpt matches what you bought. Image any concern straight away and tell the supplier before you do anything else, as a claim gets significantly harder once the doll has been used or repositioned.

After that comes the element that takes nearly every new buyer by surprise: she will feel rigid. Out of the factory, the joints are tight, which is perfectly regular and does not mean any part is broken. The joints need freeing up before you can pose her, and the technique is easy. Use a blow-dryer on a gentle setting, not hot, to soften the TPE on each joint, after that slowly move each joint through its entire range of motion, working through the neck, shoulders, elbows, wrists, hips, knees, and ankles. Never force anything, and if a joint will not move, warm it more. Spend an entire hour on this. That sounds like much, but it is the distinction among a doll you will in fact pose and a doll that ends up stuck in the same pose seeing as you gave up.

Everyone is caught out by how bulky she is compared with how she looks. A 35 kg doll doesn't seem that hefty till you're lifting her from a low position and the load is concentrated in the wrong places, so use right lifting technique, squatting down and lifting with your legs as opposed to your back. When you can, hug her, gripping under the armpits and keeping her close to your body, as the closer she is to your centre of balance, the less load you will feel. As TPE and silicone both hold warmth reasonably well, she's warmer than you expect, and she'll feel less plastic than you probably expected the first time you touch her sensibly. This is the chief reason people call their dolls lifelike, not seeing as of movement or AI, but as the material truly reacts when touched in a method that takes you by surprise.

TPE gets sticky with time, especially in high temperatures or after cleansing, so keep up a regular powdering process: a thin layer of cornstarch or baby powder applied with a soft powder brush holds the finish even and dust-free, and it should be done following every cleansing session. TPE sheds oil in time and needs replenishment, so oil her periodically: a small amount of mineral oil formulated especially for TPE dolls a few times a year maintains the cloth soft and prevents splitting, but do not go overboard, as an excess of oil makes the skin slippery and picks up attract dust faster than parched skin does.

Believe of cleansing as a process, not a one-off. After use:
1. Take out any inserts and wash them separately
2. Wash the openings with lukewarm water and mild detergent
3. Dry everything fully with drying supports (fifteen to twenty minutes)
4. Powder the exterior with cornstarch or baby powder
5. Put her away with care

This isn't optional, seeing as skip it and you will get mould building up inside her in a matter of weeks. The entire procedure takes approximately 45 minutes, which is longer than most buyers anticipate, and it's the primary reason old hands switch to removable liners, which cut that time more or less in half.

The worst error beginners make is not thinking about storage until it is a difficulty. The best method is hanging, with a heavy-duty overhead hook rated for at least 60 kg and a dedicated loop, which keeps her in one pose without putting pressure on the joints, and it is the one most veteran owners use. Lying down works too, but be careful: level surfaces are fine and bumpy ones aren't, and leaving her on her back for long stretches can press her buttocks or breasts flat, so vary the position periodically. Never leave her in bright sunlight, because UV damages both TPE and silicone and washes out wigs and coloured parts fast, so a cupboard or a covered carry case is ideal.

There's no shortage of internet opinions about owning dolls, and most of them are wrong or exaggerated. Yes, she's hefty and her joints need attention, but you shouldn't feel you have to be "careful" in the sense of walking on eggshells around her, seeing as she's designed to be used and she's not made of glass. Embarrassment isn't needed, as millions of owners own sex dolls, the sector has grown tremendously in the past ten years, and the social stigma has faded rapidly, which makes owning one a personal decision and not a flaw in character.

Treating her like a person isn't a requirement either. Certain owners build elaborate characters and personalities for their dolls, which is great and aspect of the appeal for many people, but you do not have to, and if you just wish a doll for sexual satisfaction and companionship without the roleplay, that is an entirely valid way to use one. The everyday side is the only thing you genuinely need to get right, as everything else is individual taste and no one else gets a say on how you use something you own.

Every owner develops their own procedure, and mine if it helps is straightforward. Prior to every session, ease the joints, not for the whole hour of the first time but for just a short while to verify nothing is rigid, and powder after each clean without fail. Verify the cloth test on any new clothes even if you've used the same brand before, keep a second wig to hand seeing as synthetic material takes longer to dry than you'd anticipate and you don't would like to be waiting, and keep her with care every time. Nothing here is fiddly, it is simply the procedure that maintains your doll in great condition for many years as opposed to months.

Your first month will teach you the majority of what you should know, and the missteps you make early tend to be cheap ones when you're careful. The costly issues come later, and they nearly always stem from something skipped in the early weeks. A joint freed up too aggressively, a cloth tested on the doll instead of a cloth, a storage method that seemed fine until the pressure pressed down into it. Take it slowly at the start and the rest takes care of itself.

Something will eventually go wrong, so there's also the question of what to do when it does. Maybe a tear in the armpit, a loose joint, or a blemish that will not come out. Panicking and assuming the doll is done for is the instinct, but practically everything short of a broken frame is fixable if you spot it early. TPE repair packs cost hardly anything and handle tiny splits. Loose joints can be replaced or tightened. Marks are the one thing that does not come out, which explains why the cloth try makes such a difference. Work out where the fixable difficulties are and quit worrying about the ones that aren't.

A doll is a big purchase and it deserves respect, but "serious" does not mean "difficult." Skip freeing up the joints, regular powdering, and correct storage and you will be replacing her significantly sooner than you expected, but do them and you will get years out of her. Week one is the hardest component, and after that it turns into routine. More info at this The Real Word on Sex Dolls Today- What to Expect 99f54e1 on top of A Quick Overview of Sex Dolls- Read Before You Buy and The Complete Overview of Sex Dolls Right Now- No Hype Just Facts. Also check out you can try this out for more.
[center][Image: lwje3h40r9td4hani42wf.jpg][/center]

[center]CHECK OUT THE BEST SEX DOLL GUIDE ONLINE[/center]
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Forum software by © MyBB Theme © iAndrew 2016